Bei-sensors High Resolution Inclinometers Manual de usuario descargar pdf (Pagina 3)

Version 130305 CANopen Industrial Datasheet Page 3

INCLINOMETER

CANOPEN

Installation

Electrical Connection

The inclinometer is connected via 8 pin round

connector or a Cable

Instructions to mechanically install and

electrically connect the inclinometer

Do not connect the inclinometer

under power!

Do not stand on the inclinometer!

Avoid mechanical load!

Bus Termination

If the inclinometer is connected at the end or

beginning of the bus the termination resistor

must be switched on. The termination resistor is

switched on when the dip-switch 8 is in the ‘ON’

position. To switch the resistor on, the cap of the

inclinometer have to unscrew.

Tabelle 1 Connector Assignment

There is a resistor provided in the inclinometer,

which must be used as a line termination on the

last device.

ON OFF

Bus address

The setting of the node number is achieved via

SDO-Object (see 4.2). Possible (valid)

addresses lie between 0 and 96 whereby every

address can only be used once.

The CANopen inclinometer adds

internal 1 to the adjusted device

address.

Description

P8F-Cable

+UB Supply voltage

White

RxD

Brown

TxD

Green

Ground (Supply)

Yellow

CAN Low

grey

CAN Ground

Pink

CAN High

Blue

Red

Front view of housing

Connector inclinometer

1 2 3 4 5 6 7 8

Ordering Description 8

Comentarios a estos manuales

Sin comentarios

Bei-sensors High Resolution Inclinometers Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Bei-sensors High Resolution Inclinometers